• Remove all Pillar Post from Shipping package and inspect individually for damage or bend. Next, test fit each individual piece to make they fit
• Clean the B Pillar Post section of airborne dust or other elements. Make sure the vehicle and trim temperature is above 65 degrees (avoid temperatures below 65 degrees). Clean work area with 3M adhesive cleaner or equivalent, or rubbing alcohol
  
• Ready to Peel and Stick on: Remove the entire red liner just before installing. Protect exposed tape from dust or other debris
• Hold the Pillar Post piece at a 90 degree angle to the vehicle, and touch the very top edge to the vehicle, observing your placement and alignment guides. If you need to adjust placement, simply raise the piece past 90 degrees and lift off
• Once you get the placement right press down across the top of the piece to tack it in place. Complete installation by pressing down across the Pillar Post piece, moving from top to bottom. (Caution: Once the tape adheres to your vehicle , the trim cannot be removed without causing wrinkles)
  
• Next, apply pressure over entire surface including edges with a clean soft cloth to ensure that the tape completely adheres to the vehicle. Check your edges and re-apply pressure when necessary
• Lastly, remove white protective covering.

How To Remove A Pillar Post Trim

Option 1
If you plan to remove the Door Pillar Post, my suggestion is to first use a strong Fish Line to slide between the installed Pillars and your door pillars. Start sliding from the top, using both hands from left to right and then moving downwards like using a hand saw. Once you finish removing the Stainless Pillars, simply dab some Goof Off Adhesive Remover onto the adhesive residue. Let it sit for approximately 5 minutes, then use a spat to remove adhesive residue. Repeat 2-3 times until desired result. Clean surface with Rubbing Alcohol and then Wash your car

Option 2
Try heating the Pillar Post with a Heat Gun** or Blow Dryer to loosen the adhesive, side a Fish line in between the Stainless Pillar and the Pillar Post of vehicle. Once removed, dap Goof Off with a cloth to the adhesive residue, let it stand for a couple of minutes, then remove with a spatula or paper towel. Repeat a couple of times until the adhesive is totally removed

Option 3 - No heat required
Try using a dental floss. Start by carefully sliding it back and forth, until the emblem comes off.
Again, dab some adhesive remover, clean, wax and then shine

Good Luck!

Tools Required: Latex Glove, Fish Line*, Windex, Rubbing Alcohol, Goof Off*, Spatula, Eye Protector

* Available at Walmart or your favorite Handy Store
** Use Heat Gun with caution. Do not overheat, Just hot enough to loosen the adhesive

Besides the chrome pillar post set for your Chrysler 300 and 300C, 300fx.com offers a large selection of chrome trim accessories, interior trim accessories and exterior accessories including chrome door handle covers, chrome mirror covers, after market grilles, stainless rocker panels and stainless steel rear deck trims